PROJECT PHOTOS

Foaming first layer

April 22, 2003

Foam trailer from Alpine Foam

setting up for interview

getting camera ready

foaming seal with concrete ring

side view

guest bath glass block window

first living room window buck

portico area

starting layering

around kitchen window

first layer is slower to apply

reaching up to 8 foot level

arches are complete

making smooth layers

up on scaffold level 1

under 2nd fl master bath window

coming up on two story augment

Billy and Jason changing scaffolding

covering up the light

22 feet in the air

two story augment inflated

Very exciting day, but exhausting. The first layer of foam was applied and Billy was able to film an interview with ProFoam president Dale Ledbetter. Dale was assisted by Jason and Cody. The pictures speak for themselves, the work took the longest when we were setting the window bucks. After that they just flew on the sides with no interruptions. After they got to the top, they started back down and finished around 7:30 pm. Then we cut a hole in the material for the 2 story augment and it inflated in one minute. It was just awesome. It is really big and will enhance the master suite and also the guest bedroom window. Today is rebar hanger day, we hope to finish up so ProFoam can do the final layer of 1 1/2 inches on Thursday.

manufactured by ProFoam

Billy and Dale Ledbetter

Dale and Jason (in suit)

kitchen window up

close-up of bottom of window

stuck in place

12 inch sill height

checking for level

Billy filming foaming process

up to back door

putting on 1/2 inch first

coating portico with second layer

finishing around arches

overhead in portico

Jason spraying

good view of kitchen and back door

Jason and Cody on 1st level

starting third level

close-up of the top of the dome